Yeah, yeah, yeah....I know I've posted this before.
I like it. It's cool. Watch it again.
Pretty low-perf engine they started with. Two-bolt mains, cast iron crank, cast pistons, pressed-in rocker studs, no push rod guide plates (only used with screw-in studs), and a two barrel intake manifold.
But they rebuilt it properly, with an overbore and hone, decked the block and surfaced the heads, installed hardened valve seats and a roller-type timing chain. The intake manifold and carb they used are Edelbrock street performance types, and I bet that little motor just purrs......
Subscribe to:
Post Comments (Atom)
-
FOURTH time I've written this post. MY Muse has apparently vacated the premises, leaving me too busy doing other things to keep both m... -
On Friday, the 29th, and 1215pm local time. Surrounded by family and friends, and her two dogs. Things have been a bit hectic here, as expe...
Or you can stroke a check for $2,500 or so and get up to 400 h.p. with a warranty.
ReplyDeletehttp://www.high-performance-engines.com/
Yeah, but that's not my style.....
ReplyDeleteI've lost track of how many engines I've rebuilt. Everything from just throw new bearings in it and pray it stays together, to full-on race engines.
Even "hot rodded" a couple of lawn mower and yard tractor engines!