Thursday, August 25, 2016

Still Here, Still Gettin' Greasy!

Just been busy.

I boogered up the threads on the end of the Strut Control Rod by improperly removing it (long story...), so I had to get some BIG metric taps and dies to clean up the external threads on the rod, and the internal threads in the nut.

Would have greatly preferred to use "Rethreading" taps and dies, as they remove less metal, but the "repair" came out OK, and the nut still has an acceptable level of "looseness" to the way it fits.

And I'll use some BLUE Loctite on it when I reassemble it!

*****UPDATE***** 

Got this done after I made the post....

Old control arm bushing is pressed out, and the new Energy Suspension bushing is pressed in.

Used a combination of long bolts, nuts, washers, and a couple of sockets to press it out. Pressed the new polyurethane bushing in with a big "C" clamp and my bench vise, and then got the inner metal sleeve centered with the same long bolt and nuts I used to press the old one out.

The ball joint checks out OK...NO play at all in it. I'll clean as much of the old grease (which is clean) out of it as I can, replace the rubber boot which is split, and relube it with Mobil 1 synthetic grease. Then I can put the lower control arm and strut back in, and be DONE with the driver's side of the car!

6 comments:

  1. Hoo boy ... been there, done that, cried bitter tears over my carelessness. Good job getting 'er fixed.

    ReplyDelete
    Replies
    1. Yeah,,,,I used to laugh when I heard people say "Jim has forgotten more about radio/cars/airplanes/radar/etc than you'll ever know about it!".

      Sadly, it appears I have forgotten some things!

      Oh, well....I learn well from my mistakes (I'm lazy...I HATE re-doing things!), and I sure won't repeat the mistakes I made on the other side of the car.

      Plus I now have additional TOOLS in my arsenal!

      Delete
  2. I have also had that experience more times than I care to admit.
    One item that has come in handy over the years for damaged external threads has been a set of thread files.
    But getting the proper tool to do the job is the right way to do it, even if it is something you pay dearly for and only use once.
    Glad you were able to save it!

    ReplyDelete
    Replies
    1. WELL.....I have a set of good "Made In U.S.A." thread files, and either I don't know how to use them, or they aren't as well made as I thought.

      I measured the pitch as 1.5 with my metric thread gauge, and proceeded to use the "1.5" thread file to "stroke" the damage threads back into shape.

      No dice.....either the new thread files aren't any good, I don't know how to use them, or the metal rod was been heat treated after the threads were rolled on it.

      I wound up using a "Swiss File", aka "Jeweler's File" to clean up the two/three threads at the end that were damaged.

      The nut now starts easily, and threads on the rod OK.

      Delete
  3. What, a good tight cross thread doesn't work for you?

    ReplyDelete
    Replies
    1. Makes it just a bit hard to get off the next time....

      Delete

Keep it civil, please....

Gloomy, Gritty, Grey Day

 At 1700 local it's as described in the headline; 30*F, 88% RH, completely overcast, snowing like crazy (small flakes, but lots of them)...